|
THE PITBULL
Ballistic Material Used in Construction for NIJ Level III
-
Ballistic steel - 3/8" NIJ Level III Astralloy 6.33 (can be hot formed and welded with no
loss of hardness, ballistic properties of the metal do not change when formed).
-
Glass - Laminated glass/polycarbonate w/polycarbonate layer on the interior side for spall
protection 39-41 mm NIJ Level III.
Base Vehicle Specifications & Conversions
-
The vehicle body is one integral
unit design consisting of the cab & personnel area. The OEM dash panel is incorporated into the ballistic body.
-
The cab/body including floor and roof is constructed of 3/8" ballistic plate BP6.33. All body welds are on both interior
and exterior side of the ballistic plates. Structural integrity of the body is accomplished by use of 3" channel as a roll bar in the front and rear of the personnel
compartment.
-
The rear bumper is 32" wide with a step 14" high and 16" width constructed of 1/4" steel tread plate.
-
Running boards are 8" wide and extend from the front edge of the front doors and wrap around to the rear bumper.
-
The running boards and rear bumper are fabricated as one seamless unit.
-
The front bumper is 14" wide constructed of 12" steel channel. A storage compartment is built in to the center section
of the bumper. Four tow hooks are attached to the front bumper. Two 12"
rubber bumperettes are attached to front of bumper. A grill guard constructed of 3/8” ballistic steel provides ballistic
protection to the engine compartment.
-
Additional protection to the engine compartment is provided
by welding 3/8 ballistic steel panels inside of the front fenders extending to the
front side of the cab compartment. These panels are seam welded in the cowl section of the body. Under hood 3/8" ballistic
steel panels are attached on both sides of the engine compartment with clearance for the OEM hood. These panels are bolted
in place for maintenance access. Additional 3/8 ballistic steel panels are secured behind headlights. OEM front fenders and
hood use is maintained.
|
THE BULLDOG III
The Bulldog II S.W.A.T. vehicle is built with the following
Specifications:
Security Features
and Specifications
-
P/A- Siren with 100 Watt Speaker
-
Rear 18” heavy duty bumper
-
Manual interior lock bolts on all doors
-
Fans (4) – Front compartment (2) rear (2)
-
Running boards (4” channel and 3/6 tread plate)
-
Five florescent lights – Front (1) and rear (4)
-
Red dot A/C – heater 5045
-
Heavy duty slam locks on front and side
-
Quick exit high rotary latch lock on right rear door w/security key cylinder
-
Two point lock on left rear door
-
Rear of truck fully opens
-
Quick exit rear door (rotary locks)
-
Electronic rear and side doors
-
Back up alarm
-
Rear vent fans (2)
Armoring Specifications
-
12 gauge galvanized steel
on exterior front, sides, rear, and roof
-
¼” ballistic steel on
interior front, sides and rear
-
12 gauge steel baffle plates
between exterior steel and ballistic plate
-
Ballistic resistant glass
(1. 6” thick) – No Spall (on all sides)
-
Gun ports under each window
(7)
-
Ballistic tinted glass rear
compartment
-
More details on the armoring
can be provided upon request
|
